Rental Micro fixed table Delegate and president
Rental Conference and discussion system
Low sensitivity to mobile phones u Compact, elegant and ergonomic design u Plug-in microphone u Two channel selectors indicating the number and abbreviated name of the built-in speaker u channel The discussion unit with double channel selector allows participants to speak, record a speech request and listen to the speaker. A connector is provided to connect microphones. The unit incorporates two channel selectors with headphone sockets and controls for volume adjustment on each side, allowing it to be used by two delegates at the same time. Channel selectors are useful for multilingual conferences where simultaneous interpretation is available. Each channel selector incorporates two top/bottom keys of the channel and a display indicating the number and abbreviation of each language, allowing the channel to be quickly selected for the required language. Core functions • Reduction in the level of headphone output to avoid the Larsen effect (which occurs when listening to the speaker and the microphone is turned on) When the unit is in mode Two delegates, this function is available individually • It can be converted into a complete double unit by replacing the microphone button with two independent microphone control buttons, allowing individual delegates to be identified (buttons for dual unit DCNDISBDD, to be ordered separately) •
3 | DCN-DISDCS Discussion unit with double channel selector
Controls and lights • Two alphanumeric displays for language channel selection, indicating the number and abbreviated name of the channel • Microphone button with red, green or yellow light ring. Red indicates that the microphone is active, green that the speech request has been accepted and yellow is intended for the mode « VIP » (When the Two Delegates mode is enabled on the unit, this function is available individually) • The VIP light lights up when the delegate is listed in the notepad (available only if the PC software is used) • Two headphone volume adjustment buttons • Recessed Disset Switch Connections • Plug-in microphone socket • Two 3.5 mm stereo headphone connectors • 2 m cable ending in a 6-pole cast circular connector • 6-pole circular connector for loop connections Certifications and accreditations Region Certification Europe CE Technical specifications Electrical specifications Frequency response 30 Hz to 20 kHz Headphone load impedance > 32 ohms < 1 kilohm Output power 2 x 15 mW/32 ohms Mechanical specifications Mounting On a desk (portable or fixed mounting) and recessed Dimensions (H x l x P) (without microphone) On table 61 x 190 x 116 mm Built-in 6 x 190 x 120 mm Weight 800 g Colour of the upper part Silver (RAL 9022) Base colour DCN-DISDCS-L DCN-DISDCS-D Light grey (RAL 000 7500) Anthracite (PH 10736) Order information DCN-DISDCS-L
